[IMP] point_of_sale: move POSBox AP to a less used subnet

When the POSBox boots without a network cable attached it will
automatically launch a wireless AP that people can connect to. This
allows them to configure what wireless network the POSBox should connect
to.

This wireless AP was configured to use the 10.10.0.0/24 subnet. The AP
itself was on 10.10.0.1. Although this is fine if used as intended it is
a quick way to take down an existing network if you where to plug in an
ethernet cable after the wireless AP has started. 10.10.0.1 is commonly
used by routers all over the world and plugging in a booted POSBox into
their networks will cause serious issues because the POSBox will share
the same IP as the router.

This moves the POSBox AP to the 10.11.12.0/24 subnet, with the AP on
10.11.12.1.

This also makes the DHCP server listen only on wlan0 because otherwise
you can end up with two DHCP servers on the same network which would
still break stuff.

0 files changed, 0 insertions, 0 deletions